User`s manual

NPort S8000 Series Switch Featured Functions
6-10
Coupling Control Port
Setting Description Factory Default
Coupling Control Port Select any port of the NPort S8000 to be the coupling control
port
port 3
Configuring “Turbo Ring V2”
NOTE
When using the Dual
-Ring architecture, users must configure settings for
both Ring 1 and Ring 2. In this case,
the status of both rings will appear under
“Current Status.”
NOTE
The user does not need to set the master to use Turbo Ring. If no master is set, the Turbo Ring protocol will
assign master status to one of the NPor
t S8000 in the ring. The master is only used to determine which
segment serves as the backup path.
Redundancy Protocol
Setting Description Factory Default
Turbo Ring Select this item to change to the Turbo Ring configuration page. RSTP
Turbo Ring V2 Select this item to change to the Turbo Ring V2 configuration
page.
RSTP (IEEE
802.1W/1D)
Select this item to change to the RSTP configuration page.
Enable Ring 1
Setting Description Factory Default
Enabled Enable the Ring 1 settings Not checked
Disabled Disable the Ring 1 settings
Enable Ring 2*
Setting Description Factory Default
Enabled Enable the Ring 2 settings Not checked
Disabled Disable the Ring 2 settings
*You should enable both Ring 1 and Ring 2 when using the Dual-Ring architecture.