User`s manual

NPort S8000 Series Switch Featured Functions
6-9
Configuring “Turbo Ring”
NOTE
The user does not need to set the master to use Turbo Ring. If no master is set, the Turbo Ring protocol will
assign master status to one of the NPort S8000 in the ring. The master is only used to determine which
segment serves as
the backup path.
Redundancy Protocol
Setting Description Factory Default
Turbo Ring Select this item to change to the Turbo Ring configuration page. Turbo Ring V2
Turbo Ring V2 Select this item to change to the Turbo Ring V2 configuration
page.
RSTP (IEEE
802.1W/1D)
Select this item to change to the RSTP configuration page.
Set as Master
Setting Description Factory Default
Enabled Select this NPort S8000 as Master Not checked
Disabled Do not select this NPort S8000 as Master
Redundant Ports
Setting
Description
Factory Default
1st Port
Select any port of the NPort S8000 to be one of the redundant
ports.
Port 4
2nd Port
Select any port of the NPort S8000 to be one of the redundant
ports.
Port 5
Enable Ring Coupling
Setting Description Factory Default
Enable Select this NPort S8000 as Coupler Not checked
Disable Do not select this NPort S8000 as Coupler
Coupling Port
Setting Description Factory Default
Coupling Port Select any port of the NPort S8000 to be the coupling port port 2