User`s manual

NPort S8000 Series Basic Settings and Device Server Configuration
5-21
Designated Local Port 1/2/3/4
Setting Factory Default Necessity
TCP Port No. 5001 (Port 1)
5002 (Port 2)
5003 (Port 3)
5004 (Port 4)
Required
Connection control
Setting Factory Default Necessity
Startup/None,
Any Character/None,
Any
Character/Inactivity
Time,
DSR ON/DSR OFF,
DSR ON/None,
DCD ON/DCD OFF,
DCD ON/None
Startup/None Required
The meaning of each of the above settings is given in the table below. In general, both the Connect condition
and Disconnect condition are given.
TCP Connection on
Connect/Disconnect Description
Startup/None
(default)
A TCP connection will be established on startup, and will remain active
indefinitely.
Any Character/None A TCP connection will be established when any character is received from the
serial interface, and will remain active indefinitely.
Any Character/
Inactivity Time
A TCP connection will be established when any character is received from the
serial interface, and will be disconnected when the Inactivity time out is reached.
DSR On/DSR Off A TCP connection will be established when a DSR “On” signal is
received, and will
be disconnected when a DSR “Off” signal is received.
DSR On/None A TCP connection will be established when a DSR “On” signal is received, and will
remain active indefinitely.
DCD On/DCD Off A TCP connection will be established when a DCD “On” signal is received, and will
be disconnected when a DCD “Off” signal is received.
DCD On/None A TCP connection will be established when a DCD “On” signal is received, and will
remain active indefinitely.
Parameter Copy
Apply the above setting to other serial ports, you may use the checkboxes at the bottom of the window to apply
the settings to one or more ports.