User`s manual

NPort S8000 Series Basic Settings and Device Server Configuration
5-12
RFC2217 Mode
Port Settings
TCP port (default=4001)
This is the TCP port number assignment for the serial port on the NPort S8000. It is the port number that the
serial port uses to listen to connections, and that other devices must use to contact the serial port. To avoid
conflicts with well known TCP ports, the default is set to 4001.
Data Packing
Packet length
Setting Factory Default Necessity
0 to 1024 0 Optional
Default = 0, The Delimiter Process will be followed, regardless of the length of the data packet. If the data
length (in bytes) matches the configured value, the data will be forced out. The data length can be configured
for 0 to 1024 bytes. Set to 0 if you do not need to limit the length.
Delimiter 1
Setting Factory Default Necessity
00 to FF None Optional
Delimiter 2
Setting Factory Default Necessity
00 to FF None Optional
When Delimiter 1 is enabled, the serial port will clear the buffer and send the data to the Ethernet port when
a specific character, entered in hex format, is received. A second delimiter character may be enabled and
specified in the Delimiter 2 field, so that both characters act as the delimiter to indicate when data should be
sent.