User`s manual

NPort S8000 Series Initial IP Address Configuration
3-7
4. The Property window opens automatically. Select the Communication Parameter tab, then select the
appropriate COM port for the connection (COM1 in this example). Configure the parameters for 19200, 8,
N, 1 (19200 for Baud Rate, 8 for Data Bits, None for Parity, and 1 for Stop Bits).
5. From the Property window’s Terminal page, select ANSI or VT100 for Terminal Type and click OK.
The NPort S8000 will then automatically switch from data mode to console mode.
6. After you enter the password, or if password protection was not enabled, you will be prompted to select the
terminal mode. Press 1 for ansi/vt100 and then press ENTER.