User`s manual

NPort S8000 Series Initial IP Address Configuration
3-3
3. Execute the arp -s command from your computer’s MS-DOS prompt as follows:
arp -s <IP address> <MAC address>
For example,
C:\> arp -s 192.168.200.100 00-90-E8-04-00-11
4. Next, execute a special Telnet command by entering the following exactly:
telnet 192.168.200.100 6000
When you enter this command, a Connect failed message will appear, as shown below.
5. After the NPort S8000 reboots, its IP address will assigned to the new address and you can reconnect using
Telnet to verify that the update was successful.
Telnet Console
Depending on how your computer and network are configured, you may find it convenient to use network
access to set up your NPort S8000’s IP address. This can be done using Telnet.
1. From the Windows desktop, select Start  Run, and type the following in the Run window:
Telnet 192.168.127.254
If your IP address is different from the default setting, use your IP address instead. Click OK.