User`s manual

NPort S8000 Series Switch Featured Functions
6-70
Now Active Indicate the in used communication protocol. It may be Turbo Ring, Turbo Ring V2,
RSTP, or none.
Ring 1/2
Status Healthy The ring is operating normally
Break The backup link is active in the Ring.
Master/Slave Indicate NPort S8000 is in the Master mode or Slave mode of the Turbo Ring 2.
1st/2nd Ring Port Status Link down No connection
Blocked This port is connected to a backup path and the path is blocked
Forwarding Normal transmission
Learning Learning
Coupling Mode Indicates current coupling mode
It may be None, Dual Homing, or Ring Coupling.
Coupling Port status Indicate which port is used to be coupling port (port 1 to port 5). Available when
Ring Coupling in communication redundancy setting page is enabled
Restart
Restart System
Go to Restart System under Restart and then click Restart to restart the NPort S8000. Ensure that you save
all your configuration changes before you restart the system or else these changes will be lost.
Restart Serial Port
Go to Restart Ports under Restart and then select the ports to be restarted. Click Select All to select all the
ports. Click Submit to restart the selected ports.