Specifications

Industrial Networking Solutions
8-45
[e-mail]
www.moxa.com
8
Serial Device Servers >
NE-4100 Series
NE-4100 embedded device servers can be configured to send an
SNMP trap or e-mail under the following conditions:
Cold/warm start•
Password authentication failure•
Easy on-site confi guration of network settings•
Simple command frame format•
Comprehensive command set for serial and network confi guration•
SNMP and E-mail Alerts for Event Trap and Notifi cation
On-site Confi guration with Serial Command Mode
NE-4100 Series
10/100 Mbps embedded serial device servers
10/100 Mbps Ethernet interface ›
Up to 230.4 Kbps baudrate support ›
Choice of operation modes: Real COM, TCP Server, TCP Client, ›
and UDP
DHCP, BootP, Static IP, and ARP supported ›
SNMP and e-mail alerts for event trapping and notifi cation ›
Half the size of a credit card—only 57 × 40 mm ›
Low power consumption at 1.5W, with single +5V input ›
Moxa’s NE-4100 embedded device servers are designed for
manufacturers who want to add sophisticated network connectivity
to their serial devices. Moxa’s embedded device servers can be used
to convert any device with a standard serial interface to an Ethernet-
enabled device in no time. The NE-4100 embedded device servers
Overview
Change in DSR/DCD line signal•
Change in IP address•
Change in password•
support 10/100 Mbps Ethernet, and provide ready-to-use operation
modes, including TCP Server, TCP Client, and UDP. In addition, a
Real COM driver is included for backward compatibility with legacy
software.
Typical Installation Examples
NE-4110: RJ45 Ethernet connector in
stand-alone form factor
NE-4120: Pin-header Ethernet in
stand-alone form factor
NE-4100T: Dual-in-line pin header in
drop-in form factor
Easily switch between software and hardware triggers•
Software reset•
NE-4120S/4120A
NE-4100T
NE-4110S/4110A
The certifi cation logos shown here apply to some or all of the products in this
section. For details, see “Regulatory Approvals” under “Specifi cations” below.