User`s manual

NE-4100 Series User’s Manual Initial IP Address Configuration
5-6
be used for this purpose, although you are free to choose among other terminal emulators that are
widely available. PComm Lite may be downloaded at www.moxa.com.
The following instructions show the procedure using PComm Lite. If you are using another utility,
the instructions may vary slightly.
1. Plug one end of a serial cable into the RS-232 DEBUG (P1) serial port on the evaluation
board; plug the other end directly into your computer’s male RS-232 serial port.
2. From the Windows desktop, click on Start Æ Programs Æ PComm Lite Æ Terminal
Emulator.
3. When the PComm Terminal Emulator window
opens, select Open from the Port Manager
menu, or simply click on the Open icon.
4. The Property window opens automatically. On
the Communication Parameter tab, select the
appropriate COM port for the connection, COM1
in this example. The parameters should be set to
19200 for Baud Rate, 8 for Data Bits, None for
Parity, and 1 for Stop Bits.
5. On the Terminal tab, select ANSI or VT100 for
Terminal Type and then click OK.
If you select Dumb Terminal as the terminal
type, some of the console functions—especially
the Monitor function—may not work properly.
6. Enter any character to switch automatically from data mode to console mode.
7. The serial console will open up. At this point, it
will look exactly the same as the Telnet console.
Please continue to step 3 in the previous Telnet
Console section for the rest of the instructions on
setting up the IP address.