User`s guide

NE-4100 Series Serial Command Mode User’s Guide
Page 4
OP Code
Settings
Parameter Device setting
Aa
|
Ap
xxx.xxx.xxx.xxx
|
xxx.xxx.xxx.xxx
(e.g., 255.255.255.0)
Accessible Netmask 01
|
Accessible Netmask 16
Operation Mode
OM 0: Real COM
1: TCP Server
2: TCP Client
3: UDP Mode
Operation Mode
TCP Server Mode
TM 1 – 4 Max. number of connections
TL 0 – 65535 Local List Port
TT 0 – 99 (minutes) TCP Alive Check Timeout
TI 0 – 65535 (ms) Inactivity Timeout
TX 0: Disable
1: Enable 1 character
2: Enable 2 characters
Number of delimiters
TY ascii character
(e.g., ‘a1’)
Delimiter 1
TZ ascii character
(e.g., ‘a1’)
Delimiter 2
TF 0 – 65535 (ms) Force Tx Timeout
Real COM Mode
RM 1 – 4 Max. number of connections
RT 0 – 99 (minutes) TCP Alive Check Timeout
RX 0: Disable
1: Enable 1 character
2: Enable 2 characters
Number of delimiters
RY ascii character
(e.g., ‘a1’)
Delimiter 1
RZ ascii character
(e.g., ‘a1’)
Delimiter 2
RF 0 – 65535 (ms) Force Tx Timeout
TCP Client Mode
CM 0: Startup
1: Any character
Connect Mode
CA xxx.xxx.xxx.xxx
(e.g., 192.168.1.1)
Destination Host IP 1
CB xxx.xxx.xxx.xxx
(e.g., 192.168.1.1)
Destination Host IP 2
CC xxx.xxx.xxx.xxx
(e.g., 192.168.1.1)
Destination Host IP 3
CD xxx.xxx.xxx.xxx
(e.g., 192.168.1.1)
Destination Host IP 4