User`s guide

NE-4100 Series Serial Command Mode User’s Guide
Page 3
Reply Code
Settings Comments
Y Command was executed successfully
1 Command not supported
2 OP code not supported
3 Invalid command encapsulation
4 Invalid parameter
5 Invalid return value
E Enter serial command mode
OP Code / Parameter
OP Code
Settings
Parameter Device setting
Basic Commands
BS read only Serial Number
BV read only Firmware Version
BN alphanumeric
(Max. 15 bytes)
Device Name
BW 0: Disable
1: Enable
Web Console
BT 0: Disable
1: Enable
Telnet Console
BP alphanumeric
(Max. 10 bytes)
Password
BR 1: Restart only
2: Save & Restart (Write
Only)
Save and Restart
NC 0: Static
1: DHCP
IP Configuration Method
NP xxx.xxx.xxx.xxx
(e.g., 192.168.127.254)
IP Address
NM xxx.xxx.xxx.xxx
(e.g., 255.255.0.0)
Netmask Address
NG xxx.xxx.xxx.xxx
(e.g., 192.168.1.254)
Gateway Address
NA Read only
(e.g., 00:90:e8:09:44:fe)
MAC Address
Accessible IP
AS 0: Disable
1: Enable
Enable IP Filter
AA
|
AP
xxx.xxx.xxx.xxx
|
xxx.xxx.xxx.xxx
(e.g., 192.168.127.1)
Accessible IP Address 01
|
Accessible IP Address 16