User`s guide

NE-4100 Series Serial Command Mode User’s Guide
Page 22
Example 3: Get IP Mode using SW Trigger
STEP 1: Configure trigger mode to SW trigger, and check the three trigger characters. For
this example, assume the trigger is “2B 2B 2B” (Chap. 4).
STEP 2: Check NE’s serial port settings (Chap. 5).
STEP 3: Start Windows HyperTerminal and set PC’s serial port settings to the same settings
recorded in STEP 2.
STEP 4: Use HyperTerminal to send the three trigger characters used to enter Serial
Command Mode; “2B 2B 2B” in this example.
STEP 5: HyperTerminal displays “<E” (indicates NE is in Serial Command Mode).
STEP 6: Use HyperTerminal to send “>RNC\n” (command to request NE’s IP Mode).
STEP 7: HyperTerminal displays “<YNC1\r” (indicates NE’s IP Mode = DHCP).
STEP 8: Use HyperTerminal to send “>WBR0\n” (command to exit Serial Command
Mode).
NOTE
When using MOXA PComm Terminal, instead of HyperTerminal, use “CR” (carriage return) in
place of “Enter”.
Example 4: Change TCP Port Number using SW Trigger
STEP 1: Configure trigger mode to SW trigger, and check the three trigger characters. For
this example, assume the trigger is “2B 2B 2B” (Chap. 4).
STEP 2: Check NE’s serial port settings (Chap. 5).
STEP 3: Start Windows HyperTerminal and set PC’s serial port settings to the same settings
recorded in STEP 2.
STEP 4: Use HyperTerminal to send the three trigger characters used to enter Serial
Command Mode; “2B 2B 2B” in this example.
STEP 5: HyperTerminal displays “<E” (indicates NE is in Serial Command Mode).
STEP 6: Use HyperTerminal to send “>WTL4001\n” (sets TCP Server Port No. = 4001).
STEP 7: HyperTerminal displays ”<YTL\r” (indicates command was executed successfully).
STEP 8: Use HyperTerminal to send “>WBR2\n” (saves modification and restarts NE
module).
STEP 9: Repeat STEP 1 to STEP 5.
STEP 10: Use HyperTerminal to send “>WBR2\n” (saves changes and restarts NE Module).
STEP 11: HyperTerminal displays ”<YTL4001\r” (indicates TCP Server’s TCP Port No. =
4001).
STEP 12: Use HyperTerminal to send “>WBR1\n” (command to exit Serial Command
Mode).
NOTE
When using MOXA PComm Terminal, instead of HyperTerminal, use “CR” (carriage return) in
place of “Enter”.