User`s guide

NE-4100 Series Serial Command Mode User’s Guide
Page 18
8
8
Chapter 8 SW Reset Function
Network Enabler Administrator provides an easy way to enable NE-4100-CMD’s software reset
function. To enable this function, open the NE’s Configuration page, .click on the Digital IO tab,
and then check the Enable SW RESET Function (Use DIO 1) checkbox.
As indicated, the RESET command will be transmitted through GPIO1.
! SW Reset Pin: GPIO 1
! Reset is executed by pulling GPIO 1 low (normal is pulling high)
a. Pull 3 sec. to erase the password.
b. Pull 10 sec. to load factory defaults.
NOTE
The SW Reset function is disabled by default. If SW Reset is enabled, then since “disable” is the
default, it will be reset to “disabled” automatically after receiving a 10 sec. SW Reset command.
This helps to prevent users from resetting to the default values inadvertently.