User`s guide

NE-4100 Series Serial Command Mode User’s Guide
Page 15
6
6
Chapter 6 Exiting Serial Command Mode
There are three ways to exit Serial Command Mode. All settings made while in command mode
will be stored in RAM. After excuting Save / Restart, the settings will be saved in the flash
memory.
1. Power Off
Configuration will not take effect after powering back on, since the modifications were not
saved.
2. Exit by Command (OP Code: BR)
There are two possible exit behaviors
! Save & Restart
! Restart only (modifications will not be saved)
3. Auto Restart
If 5 minutes elapses without inputting a valid command, then the NE unit will auto-restart
without saving modifications.