User`s guide

NE-4100 Series Serial Command Mode User’s Guide
Page 9
3. Once the NE-4100-CMD is located, click on the product’s Model to highlight it, and then
click the right mouse button. Select the Configuration option.
4. Check the Modify box to change the configuration. If the Enable box is not checked, then
Serial Command Mode is disabled. There are two Enable options:
HW Trigger
SW Trigger
Select H/W Control Pin (Use DIO 0)
to tri
gg
er Command Mode b
y
hardware.
Select Activated by Character to
trigger Command Mode by software. In
this case, you will also need to enter the
three characters (in HEX format) that
will be used as the trigger characters.