User`s guide

NE-4100 Series Serial Command Mode User’s Guide
Page 8
4
4
Chapter 4 Configuring Serial Command Mode by
Entering Trigger Type
In this chapter, we explain how to configure the type of trigger (hardware or software) that will
activate Serial Command Mode. The trigger type can configured over the network with Network
Enabler Administrator, Telnet Console, or Web Console, or through the serial console port by
Serial Console.
Network Enabler Administrator
Network Enabler Administrator 2.6 provides a convenient way to configure NE-4100-CMD.
1. After installing Network Enabler Administrator 2.6, double click on the shortcut icon on
your Windows desktop to start the program.
2. Use Broadcast Search or Search by IP to locate the NE-4100-CMD you wish to configure.
Keep in mind that Broadcast Search will locate all Network Enabler products connected to
the same LAN as your PC. Search by IP can be used to locate Network Enablers that are
NOT connected to the LAN. However, if you use Search by IP to locate a Network Enabler
connected to the same LAN as your PC, the Network Enabler and PC must be on the same
subnet.