Installation guide

2
Automatic Installation - for C218T/PCI and C32010T/PCI only
The examples in this section where produced using MOXA Intelligent C218T/PCI, which
is an 8-port, RS-232/422/485 PCI Multiport Board for embedded systems. If you are
installing an C32010T/PCI multiport board, the procedures you need to follow may be
slightly different, but you should be able to use this as a guide to see how to install and
manage your board.
Installing the C218T/PCI Multiport Board
1. After first making sure your PC is powered off, remove the PC’s cover and insert your
C218T/PCI Multiport Board into an empty PCI slot.
2. Replace the PC’s cover and then power-up the computer.
3. The Windows XP operating system will automatically alert you with the Found New
Hardware message shown in the following figure.
4. After waiting several seconds, the Windows XP Found New Hardware Wizard will
automatically start up. Insert the software CD or diskette containing the Intellio driver
software into either the CD or floppy disk drive. Select the Install the software
automatically option, and then click on Next to continue.