User's Manual

A-2 Moxa Internet Sharer User’s Manual
§ Check your cable connection between Internet Sharer and your PC
§ Check the LAN LED on the Internet Sharer. If the port connected to
your computer is not lit on, check the network cable connections on
both the Internet Sharer site and your Computer site. If it is
connected, but the LAN LED still isn t lit, try another cable.
§ Check if your LAN driver and TCP/IP protocol is properly installed
on your PC. Following are the commands to show how is the
configuration at your platform now. If you can
address, you may go to Chapter 6 to check your LAN card and
TCP/IP setting again.
§ On Windows 95: Run winipcfg from Run on the Start menu. Your
PC should have an IP address of 192.168.10.n, where n is from 2 to
254. If the IP address is not in this range, click Release and then
click Renew.
§ On Windows NT: Type ‘ ipconfig’ from the command prompt. Your
PC should have an IP address of 192.168.10.n, where n is from 2 to
254. If the IP address is not in this range, try ipconfig /release
release then try
§ There may have duplicate Internet Sharer IP on your LAN. Power
down the Internet Sharer and try to ping 192.168.10.1 or the current
Internet Sharer IP address. If you can get the response, you have
another machine with the same IP. You may choose to change the IP
address of your machine. Or you may change the IP address of
Internet Sharer. You have be aware to power down your machine
before power on Internet Sharer.
§ If you have already installed the Ethernet card and TCP/IP, try to
remove the driver and reinstall it. Check if your Ethernet card has
been removed for some reason. This could happened if you are