User's Manual

6-10 Moxa Internet Sharer User’s Manual
Setting Up a Windows NT Network
Installing Network Card on Windows NT
Log on as a member of the Administrators group for the local computer
to install and configure TCP/ IP. Follow these steps to install network
card on a Windows NT computer:
1. Right click the Neighborhood on the desktop and click on
Properties.
2. Choose Adapter. Select Add. The system will show you a list of
network card. Follow your network card manual to choose the card
type you have or install from a disk and click OK to continue.
3. After the system installing the software for your card, Windows NT
system will prompt you a dialog box to configure the TCP/IP
protocol if your NT system already have TCP/IP driver installed.
You may continue with the section below which describes how to
configure TCP/IP.
4 Note: The Windows NT 4.0 system asks you about installing some
network protocols while installing the system. If your system
do not have the TCP/IP protocol installed, you may follow
the steps above and choose protocol to add TCP/IP.