User`s manual

MGate MB3000 User’s Manual Configuring the Modbus Gateway
4-8
Password (an alphanumeric string)
You can set a password to prevent
unauthorized users from configuring
the unit. The password will be required
when anyone attempts to configure the
unit over the network. Modbus
operation is not affected by the
password.
Confirm password (an alphanumeric string)
Re-type the password again for
confirmation.
ATTENTION
To erase an existing password, leave both the New Password and Confirm Password text input
boxes blank. The password will be erased when you click OK in the bottom right corner.
Configure Serial Communication Parameters
The Serial tab is where each serial port’s communication parameters are configured. You can
configure Baud Rate, Parity, Data Bits, Stop Bit, Flow Control, FIFO, and Interface Mode.