User`s manual

MGate MB3000 User’s Manual Getting Started
2-10
STEP 2:
Use the DIN-rail attachments to hook the
unit onto the DIN-rail, as shown.
STEP 3:
Gently but firmly snap the unit into place. The
attachments should fit snugly over the top and
bottom edges of the DIN-rail.
NOTE: The DIN-rail mounting kit is an optional accessory.
To remove the unit from the DIN-rail, hold the unit with both hands and use your fingers to pull
the attachments off the bottom edge of the DIN-rail. Once the attachments have been unhooked
from the bottom edge, you should be able to lift the unit off the rail.
Wall Mount
The unit can be mounted on the wall using two screws, as shown below.
MGate MB3180
STEP 1:
Position the two screws on the wall 7.8 cm apart horizontally, as shown. Make sure the heads are
6.5 mm in diameter or less, with shafts at 3 mm in diameter or less. Tighten the screws but leave
about 2 mm of space between the head and the wall.
7.8 cm
6.5 mm
STEP 2:
Hang the unit on the wall by placing the keyhole
shaped apertures over the screws, then sliding
the unit downwards as indicated shown.
STEP 3:
For added stability, tighten the screws.