User`s manual

MGate 4101-MB-PBS UM Configuration
4-17
NOTE
Each “ID” of the commands must be mapped, that is, the commands in Modbus will correspond with the I/O
module in PROFIBUS
QuickLink
The QuickLink is an innovative function to let you configure more quickly and easily, Typically, most PROFIBUS
users must spend a lot of time to set up Modbus commands in a PROFIBUS application. By using the QuickLink
function, the MGate 4101-MB-PBS will learn Modbus requests automatically, to save time in deployment.
However, the function is only enabled in Modbus master mode. (Please refer to the Typical Application in the
Appendix for more details). Start QuickLink by clicking the QuickLink button.
It takes a period of time to learn the Modbus requests. Begin by clicking the Start button, which will change the
Status to On Learning. The number of Learned Requests will increase as the MGate 4101-MB-PBS learns each
request. When you are sure all requests have been learned by the MGate 4101-MB-PBS, click the Stop button,
then click the Next button to continue QuickLink.