User`s manual

MGate 4101-MB-PBS UM Configuration
4-8
Specify by IP Address
Specify by IP Address is used for MGate Ethernet Gateways, such as the MGate MB3000 and MGate EIP3000
series, which are discovered via Ethernet by using a specific IP address. Click Specify by IP Address if you
know the IP address of the unit and wish to connect to it directly.
ATTENTION
If Search by IP Address fails to locate the MGate MB3000 or MGate
EIP3000 series, the IP address that you
entered might be incorrect. Try doing the search again and re
-entering the IP address carefully.
Another possibility is that the MGate MB3000 or MGate
EIP3000 series is located on the same LAN as your PC,
but on a different subnet. In this case, you can modify your PC’s IP address and or netmask so that it is on the
same subnet as the MGate MB3000 or MGate EIP3000 series. After your PC and the MGate MB3000 or MGate
EIP3000 series are on the same subnet, MGate Manager should be able to find the unit.
Connect through COM Port
Connect through COM Port is used for MGate PROFIBUS Gateways, such as the MGate 4101-MB-PBS series,
which are discovered via RS-232 serial COM Port. Click Connect through COM Port if you know the COM port
number of the unit.
Search
Click Search to begin searching the serial console for the MGate 4101-MB-PBS units.
A dialog box will appear. Click Connect through COM Port and choose which COM port is used to connect to
MGate 4101-MB-PBS.