User`s manual

MGate 4101-MB-PBS UM Configuration
4-7
When you click OK, MGate Manager will immediately reflect your chosen language.
After changing to a different language, you will find that all strings on MGate Manager are replaced in your
chosen language. For example, the above picture is shown in traditional Chinese. However, no matter what
language you choose, it won’t change the label on the language button.
ATTENTION
Set your MGate Manager to “
Default Language” before contacting Moxa Technical Support.
With support for multiple languages, MGate Manager is more user
-friendly and accessible. However, if you
need assistance from Moxa Technical Support, please change the language to “Default Language”. This will
prevent any misunderstandings or confusion about MGate Manager menu items and commands as our
engineers assist you.
The default language is English and will only be active for the current MGate Manager session. When you open
MGate Manager again, the language will revert to your original setting.
Connecting to the Unit
Prior to configuration, MGate Manager must be connected to its unit. There are three methods to establish
connection. Broadcast Search locates the MGate series on the LAN and each MGate 4101-MB-PBS connected to
a PC COM port. Search by IP attempts to connect to a specific unit by IP address, which is useful if the unit is
located outside the LAN or can only be accessed by going through a router. Connect through COM port tries to
connect to a separate unit via a RS-232 serial COM port.
Broadcast Search
Broadcast Search is used for MGate Ethernet Gateways, such as the MGate MB3000 and MGate EIP3000
series, which are discovered via Ethernet by using broadcast IP. In addition, whenever you add an MGate
4101-MB-PBS via serial console, the MGate Manager will automatically record the COM port(s) for the
broadcast to search as well. Note that restarting the MGate Manager will erase the COM port(s) record.