Specifications

Total Solutions for Industrial Device Networking
9-31
Remote I/O Servers
www.m o x a . c o m e - m a i l : i n f o @ m o x a . c o m
9
E3210
LAN
Ethernet: 10/100 Mbps, RJ45
Protection: 1.5 KV magnetic isolation
Protocols: Modbus/TCP, TCP/IP, UDP, DHCP, Bootp, SNMP(MIB for I/O
and Network), HTTP, SNTP
Power Requirements
Power Input: 24 VDC nominal, min 12 VDC, max 48 VDC
DO Power: 24 VDC nominal, up to 36 VDC
Mechanical Specifications
Wiring: I/O cable max. 14 AWG
Environmental
Operation Temperature: -10 to 60°C (14 to 140°F), 5 to 95% RH
Storage Temperature: -40 to 85°C (-40 to 185°F), 50 to 95% RH
Digital Input
Inputs: 8, source type
I/O Mode: Digital Input
Dry Contact: Logic 0: close to GND
Logic 1: open
Wet Contact: Logic 0: 0 to 3 VDC
Logic 1: 10 to 30 VDC
Isolation: 2 KVrms
Common Type: 8 points/1 COM
Stored Counter Value: Yes
Digital Output
Output: 8, sink type
I/O Mode: Digital Output
Ethernet Peer-to-Peer I/O Server 8 Digital Inputs, 8 Digital Outputs
Specifications
Features
Remote digital input mapped to local digital output over Ethernet
High speed peer-to-peer I/O
Copy sensor signals to up to sixteen locations
Quick and easy utility and web-based settings
Local alarm and remote alarm message
Support Modbus/TCP for remote monitoring
Introduction
Direct input-to-output communication over IP
The ioMirror E3000 Ethernet I/O server is designed as a cable-
replacement solution that connects remote digital input signals to output
signals over an IP network. The ioMirror E3210 provides 8 digital input
and 8 digital output channels and a 10/100M Ethernet interface. Up
to 8 pairs of digital input and output signals can be exchanged over
Ethernet with another ioMirror E3210 as well as to a local PLC or DCS
controller. Over a local area network, the ioMirror achieves low signal
latency, typically 20 ms. With ioMirror servers, remote sensors can now
be connected to local controllers or display panels over copper, fiber,
or wireless Ethernet infrastructures. Signals can be transmitted over
virtually unlimited distances, without noise problems.
Split sensor signals to sixteen different locations
The ioMirror E3000 can split one input signal to two digital output
channels at two different IP addresses. Eight tank level signals could
be monitored at sixteen different display panels at the same time.
Local alarm with remote alarm messages to monitor con-
nectivity
The ioMirror E3210 has a 24 VDC alarm output channel that can
activate an attached buzzer or display LED when the connection fails.
In addition, both ioMirror modules can send messages to the event log
software. This ensures that at least one of the warning messages will
reach the event log software.