Specifications
Industrial Networking Solutions
5-21
info@moxa.com
www.moxa.com
5
Industrial I/O >
ioLogik E2262
Active Ethernet I/O with 8 thermocouple inputs and 4 digital outputs
ioLogik E2262
Supports J, K, T, E, R, S, B, and N type thermocouple and ›
mV modes
Conversion Time: Less than 90 ms ›
Instant event messaging by TCP/UDP/email/SNMP-Trap ›
PC-based confi guration utility and web console ›
Easy-to-use Click&Go™ Logic for local output control ›
Windows/WinCE VB/VC.NET and Linux C APIs ›
I/O control over Modbus/TCP and SNMP protocol ›
NIST traceable calibration ›
Specifi cations
Ordering Information
Introduction
Extend the Wiring Length
The ioLogik E2262 can extend the wiring length of your sensors up to
10 fold. For example, whereas the wiring for a J-Type may normally
extend only 10 m, the ioLogik E2262 can be used to increase the
J-Type TC wiring length up to 100 m.
More Accurate Temperates
The ioLogik E2262 has two cold junction compensation sets and
supports digital filtering. Calibration, linearization, and calculation
are based on the devices traced by the NIST (National Institute of
Standards and Technology), and are stored in memory to eliminate
this source of error. The ioLogik E2262 can also detect burnout and
disconnection.
I/O Pin Assignment
I/O (left to right)
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
TC0 +
TC0 -
TC1 +
TC1 -
TC2 +
TC2 -
TC3 +
TC3 -
TC4 +
TC4 -
TC5 +
TC5 -
TC6 +
TC6 -
TC7 +
TC7 -
DO.GND
DO.GND
DO0
DO1
DO2
DO3
DO.PWR
Thermocouple Input
Channels: 8
Sensor Type: J, K, T, E, R, S, B, N type TC and mV mode
Conversion Time: Less than 90 ms
Effective Resolution: 16 bits
Accuracy:
±0.1% FSR @ 25°C
±0.3% FSR @ -10 and 60°C
Input Impedance: 1 M ohm or better
Digital Output
Channels: 4, sink type, 36 VDC, 200 mA
I/O Mode: DO or Pulse Output (up to 100 Hz)
Pulse Wave Width/Frequency: 10 ms/100 Hz
Over-voltage Protection: 45 VDC
Over-current Limit: 750 mA
Over-temperature Shutdown: 175°C
Isolation: 3K VDC or 2K Vrms
ioLogik E2262: Active Ethernet I/O with 8 thermocouple inputs and 4 digital outputs
LDP1602: LCD module with 16 x 2 text and 5 buttons
The certifi cation logos shown here apply to some or all of the products in this
section. For details, see “Regulatory Approvals” under “Specifi cations” below.