Specifications

5-20
www.moxa.com
[e-mail]
Remote Monitoring Solutions
Industrial I/O >
ioLogik E2260
5
Active Ethernet I/O with 6 RTD inputs and 4 digital outputs
ioLogik E2260
Supports PT, JPT, Ni RTD sensor types and resistors ›
Adjustable RTD sampling rate ›
Instant event messaging by TCP/UDP/email/SNMP-trap ›
PC-based confi guration utility and web console ›
Easy-to-use Click&Go™ Logic for local output control ›
Windows/WinCE VB/VC.NET and Linux C APIs ›
I/O control over Modbus/TCP and SNMP protocol ›
NIST traceable calibration ›
Specifi cations
Pin Assignment
I/O (left to right)
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
EX0 IN0+ IN0- EX1 IN1+ IN1- EX2 IN2+ IN2- EX3 IN3+ IN3- EX4 IN4+ IN4- EX5 IN5+ IN5- DO.GND DO0 DO1 DO2 DO3 DO.PWR
Ordering Information
Introduction
Bring Intelligence to Temperature Measurement
The ioLogik E2260 brings intelligence to temperature sensors. It
comes equipped with virtual channels that are designed to calculate
the average value of each channel and the difference between two
channels. And it does all this without a controller or PC.
Compatible with Popular RTD Temperature Sensors
The ioLogik E2260 offers PT100, PT1000, JPT, and Ni sensor types
and a resistor of up to 2.2 kilo-ohms, and supports using your
own resistance sensor, such as PTC or NTC types for your HVAC
applications.
RTD
Channels: 6
Input Type: Pt, JPt, Ni, RTD sensor, resistor
Sampling Rate: 12 samples/sec (all channels)
Resolution: 0.1°C or 0.1 ohm
Accuracy:
±0.1% FSR @ 25°C
±0.3% FSR @ -10 and 60°C
Input Impedance: 625K ohms (min.)
Digital Output
Channels: 4, sink, 36 VDC, 200 mA
I/O Mode: DO or Pulse Output
Pulse Wave Width/Frequency: 10 ms/100 Hz
Over-voltage Protection: 45 VDC
Over-current Limit: 750 mA
Over-temperature Shutdown: 175°C
Isolation: 3K VDC or 2K Vrms
ioLogik E2260: Active Ethernet I/O with 6 RTD inputs and 4 digital outputs
LDP1602: LCD module with 16 x 2 text display and 5 buttons
The certifi cation logos shown here apply to some or all of the products in this
section. For details, see “Regulatory Approvals” under “Specifi cations” below.