Specifications

Industrial Networking Solutions
5-15
[e-mail]
www.moxa.com
5
Industrial I/O >
ioLogik E2210
ioLogik E2210
Specifi cations
Instant event messaging by TCP/UDP/email/SNMP-trap ›
Easy-to-use Click&Go™ Logic for local output control ›
12-point 24 VDC digital input with counter ›
8-point 24 VDC digital output with pulse output ›
PC-based confi guration utility and web console ›
I/O control over Modbus/TCP and SNMP protocol ›
Windows/WinCE VB/VC.NET and Linux C APIs ›
Peer-to-Peer I/O without controller ›
Introduction
Simple Applications without Programming
The ioLogik E2210 can convert a trigger event result directly into a
digital alarm output. This can be set up using the ioAdmin UI to define
an IF-THEN Logic rule, eliminating the need to write programs for PCs
or controllers.
Software Event Counter Input and Pulse Output
Each digital input can be independently configured for DI or Event
Counter mode, and output can be independently configured for DO or
Pulse Output mode.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
DI.COM DI0 DI1 DI2 DI3 DI4 DI5 DI6 DI7 DI8 DI9 DI10 DI11 DI.GND DO.PWR DO0 DO1 DO2 DO3 DO4 DO5 DO6 DO7 DO.GND
Pin Assignment
I/O (left to right)
Ordering Information
Active Ethernet I/O with 12 digital inputs and 8 digital outputs
Digital Input
Channels: 12, source type
Sensor Type: NPN, Dry contact
I/O Mode: DI or Event Counter (up to 900 Hz)
Dry Contact:
• Logic 0: short to GND
• Logic 1: open
Wet Contact:
• Logic 0: 0 to 3 VDC
• Logic 1: 10 to 30 VDC (DI COM to DI)
Common Type: 12 points per COM
Isolation: 3K VDC or 2K Vrms
Counter/Frequency: 900 Hz
Digital Filtering Time Interval: Software selectable
Over-voltage Protection: 36 VDC
Digital Output
Channels: 8, sink type, 36 VDC, 200 mA
I/O Mode: DO or Pulse Output (up to 100 Hz)
Pulse Wave Width/Frequency: 10 ms/100 Hz
Over-voltage Protection: 45 VDC
Over-current Limit: 400 mA (typical)
Over-temperature Shutdown: 175°C (min.)
Output Current Rating: Max. 200 mA per channel
Isolation: 3K VDC or 2K Vrms
ioLogik E2210: Active Ethernet I/O with 12 digital inputs and 8 digital outputs
LDP1602: LCD module with 16 x 2 text display and 5 buttons
The certifi cation logos shown here apply to some or all of the products in this
section. For details, see “Regulatory Approvals” under “Specifi cations” below.