User`s manual

3-22 Intellio CP-204J User’s Manual
In the “Individual Port Setting” dialog box, you may have two ways to map the
physical ports to COM numbers depending on the check box “
Auto
Enumerating COM number
”.
l Sequential Port Mapping: (Enable “Auto Enumerating COM number”)
Specify the COM number of the first port and subsequent ports are mapped
to continuous COM numbers. For instance, if first port is mapped to
COM10, then second port is mapped to COM11 sequentially.
l Non-sequential Port Mapping: (Disable “Auto Enumerating COM number”)
Specify the COM number for individual port. For instance, the second port
can be out of sequence, say COM18, while the first port is mapped to
COM10.
In “Individual Port Setting” dialog box, you may click on [
Advanced Setting]
button to tune the advanced features, “
UART FIFO” and “Transmission
Mode
”, for each port for particular performance requirements.
Note ! You may skip the following settings and go directly to the next step
2
if you do not require any particular performance tuning for the
driver.