User`s manual

Intellio CP-204J User’s Manual 2-1

2 Hardware Installation

The installation of Intellio CP-204J consists of hardware installation and software

installation. For software installation, please refer to the respective section of

operating systems in the next chapter. Hardware installation is stated in this chapter.

The no-switch-no-jumper

Intellio CP-204J board’s hardware configuration for IRQ

and memory addresses is automatically assigned by PCI BIOS. Hence, it is a must to

have the board plugged first before installing software driver. After this, simply

install the control board into the PC and connect the connection cable to the device.

Step 1: Power off the PC.

Warning ! Make sure your system is switched off before you start

installing any board. If you don't, you may risk damaging

your system and the board.

Step 2: Remove the PC’s cover.

Intellio CP-204J