Specifications

11
Chapter 3 Software Installation
The C114HI boards are compatible with various operating systems such as SCO
UNIX/XENIX, OS/2, QNX, PICK OS, MUMPS, Linux, and IMS Multiuser DOS.
Please refer to the relative operating system's manual for how to configure the board.
The C114HI boards support Windows NT, Windows 95, DOS and Windows 3.x device
drivers. The compatible SCO UNIX/XENIX and OS/2 drivers are also described in this
Chapter.
3.1 Windows NT/95, DOS/Windows 3.x
Please refer to Chapter "For Windows NT Users" or "For Windows 95 Users", "For
DOS Users" or "For Windows 3.x Users" for more details.
3.2 SCO UNIX/XENIX
Because the SCO UNIX/XENIX has bundled a 4 port board driver, additional driver
is not necessary. The following description is based on the SCOUNIX/XENIX
driver. Under SCO UNIX/XENIX, if the C114HI is used as the first 4 port board,
one possible configuration would be:
IRQ = 4 (i.e. COM1)
I/O base address = 0x280 (Arnet compatible)
Vector = 0x2C2 (0x280 + offset 0x42)
For second 4 port board, the C114HI can be configured as:
IRQ = 3 (i.e. COM2)
I/O base address = 0x300 (Arnet compatible)
Vector = 0x342
Use the following SCO UNIX/XENIX command to start the software installation of
a new serial board:
# mkdev serial