User`s manual

Software Installation
Intellio C218Turbo User's Manual 3-13
In the “Individual Port Setting” dialog, you may have two ways to map the
physical ports to COM numbers depending on the check box “Auto
Enumerating COM number”.
 Sequential Port Mapping: (Enable “Auto Enumerating COM number”)
Specify the COM number of the first port and subsequent ports are mapped
to continuous COM numbers. For instance, if first port is mapped to COM10,
then second port is mapped to COM11 sequentially.
 Non-sequential Port Mapping: (Disable “Auto Enumerating COM
number”) Specify the COM number for individual port. For instance, the
second port can be out of sequence, say COM18, while the first port is
mapped to COM10.
In “Individual Port Setting” dialog, you may click on [Advanced Setting] button
to tune the advanced features, “UART FIFO” and “Transmission Mode”, for
each port for particular performance requirements.
Note ! You may skip the following settings and go directly to the next step 5
if you do not require any particular performance tuning for the driver.