User`s manual

2-2 Intellio C218Turbo User's Manual
JP1 (ON: install jumper) (*: default)
123456789 IRQ
ON OFF OFF OFF OFF OFF OFF OFF OFF 2
OFF ON OFF OFF OFF OFF OFF OFF OFF 3
OFF OFF ON OFF OFF OFF OFF OFF OFF 4
OFF OFF OFF ON OFF OFF OFF OFF OFF 5
OFF OFF OFF OFF ON OFF OFF OFF OFF 7
OFF OFF OFF OFF OFF ON OFF OFF OFF 10
OFF OFF OFF OFF OFF OFF ON OFF OFF 11*
OFF OFF OFF OFF OFF OFF OFF ON OFF 12
OFFOFFOFFOFFOFFOFFOFFOFF ON 15
Step 4: Choose a base memory address (occupying 16KB) which is not used by
expansion memory or other add-on boards. If you are installing more than
one C218Turbo board, each board must have a unique base memory
address.
Set the switch to one of the 6 base memory addresses using SW1 as shown
in the table below.
SW1 Dip switch settings (*: default)
123456 Base Address
ON OFF ON ON ON ON C8000*
OFF OFF ON ON ON ON CC000
ON ON OFF ON ON ON D0000
OFF ON OFF ON ON ON D4000
ON OFF OFF ON ON ON D8000
OFF OFF OFF ON ON ON DC000
Warning ! Do not use the same base memory address or IRQ number as
other device’s, especially SCSI hard disk. Otherwise, you may
suffer from system failure or even worse system damage.
SW1
JP1
ASIC
ON
1 2 3 4 5 6