User`s manual

2-8 Intellio C320Turbo User's Manual

Control Board.

C: Plug the other DB25 female end into the Basic Module's DB25 connector.

Warning! Do not use a 25-signal-pin cable to connect the Intellio

C320Turbo Control Board to the Basic Module when using the

power adapter as this will cause power crash. (One power

comes

from the power adapter while the other power comes from the

Intellio C320Turbo Control Board)

D: Connect the power adapter to the Basic Module. Keep the Basic Module's

power switch at the OFF position. If Extensive Module(s) is(are) also required,

keep the Basic Module's power switch at the OFF position until all necessary

Extensive Module(s) is (are) installed.

E: Install the power adapter to a power source, either 110V or 220V AC.

Adjustment of the AC power specification is done automatically.

Step 10: If one more Extensive Module is required, plug the DB37 to DB37 male end

of the shipped 1-meter cable into the DB37 female connector on the rear

panel of the Basic Module and the other end of the cable into the DB37

male connector on the rear panel of the Extensive Module. If more

Extensive Module is needed, connect the next Extensive Module to the

previous one as described above.

To mount the module(s) on the industrial standard 19” rack, Rack Mount

Kit, including two L-type plates and eight screws, should be applied.

Multiport Controller with Rack Mount Kit installed ( Front View )

L-type Plate

Multiport Controller

BASIC MODULE

Power

TxD

RxD

DTR

DSR

RTS

CTS

DCD

Module

Channel

Step 11: After making sure that each component has been correctly installed, you

are recommended to power on the Basic Module first and then power on

the PC system secondly.