User`s manual

Hardware Installation
Intellio C320Turbo User's Manual 2-7
25-singal-pin
Cable
Extensive Module
C320 Turbo Control BoardBasic Module
A: Set the Basic Module power switch to the OFF position. This is absolutely
necessary when installing or removing the cable, the Basic Module or the
Extensive Module(s). Power should not be switched on until you installed all
components.
B: Plug the DB25 male end of the shipped 2-meter 25-signal-pin cable into the
connector on the rear panel of the C320Turbo Control Board. Refer to the
chapter 5 for the cable pinout details.
C: Plug the other DB25 female end into the Basic Module's DB25 connector.
With power adapter ( for range extension or external power condition)
In case of range extension or external power requirement, users need a power adapter.
A: Set the Basic Module power switch to the OFF position. This is absolutely
necessary when installing or removing the cable, the Basic Module or the
Extensive Module(s). Power should not be switched on until you installed all
components.
25-singal-pin
Cable
Extensive Module
C320 Turbo Control BoardBasic Module
B: Plug the DB25 male end of the shipped 2-meter 10-signal-pin cable (the one
comes with long range extension kit or the one fabricated according to the
pinouts in Chapter 5) into the connector on the rear panel of the C320Turbo
Power Adapter