User`s manual

2-6 Intellio C320Turbo User's Manual
Step 10: Connect the first UART Module to the CPU Module. Connect the second
UART Module to the first one if necessary and so on.
For better fixation of modules, Fixing Kit is available and see the bottom view of
modules below to install.
Step 11: After making sure that each component has been correctly installed, you
are recommended to power on the CPU Module first and then power on
the PC system secondly.
l Now the installation of the external CPU/UART modules is complete. Continue to
install the software driver explained in the chapter 3.
Installing the Basic and Extensive Modules(Rackmount)
Step 9: Connect the Intellio C320Turbo Control Board to the Basic Module with
the shipped DB25 to DB25 cable as shown in the following picture.
If range extension or external power is required, please use 10-signal-pin
cable coming with long range extension kit, instead. Thus, there are two
types installation: without power adapter and with power adapter, which are
described as follows:
Without power adapter ( for normal condition )
In most cases, users need not a power adapter.
To Control Board
CPU Module
UART Module
UART Module
ScrewsMetal Plate