User`s manual

Hardware Installation
Intellio C320Turbo User's Manual 2-5
C320Turbo Control Board.
10-signal-pin
Cable
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
00
Power Adapter
UART Module
UART Module
CPU Module
C320
Turbo
Control Board
C: Plug the other DB25 female end into the CPU Module's DB25 connector.
Warning! Do not use a 25-signal-pin cable to connect the Intellio
C320Turbo Control Board to the CPU Module when using
the power adapter as this will cause power crash. (One
power comes from the power adapter while the other power
comes from the Intellio C320Turbo Control Board.)
D: Connect the power adapter to the CPU Module. Keep the CPU Module's power
switch in the OFF position. If UART Module(s) is (are) also required, keep the
CPU Module's power switch in the OFF position until all necessary UART
Module(s) is (are) installed.
E: Install the power adapter to a power source, either 110V or 220V AC.
Adjustment of the AC power specification is done automatically.