User`s manual

2-4 Intellio C320Turbo User's Manual
A: Set the CPU Module power switch to the OFF position. This is absolutely
necessary when installing or removing the cable, the CPU Module or the UART
Module(s). Power should not be switched on until you installed all
components.
B: Plug the DB25 male end of the shipped 2-meter 25-signal-pin cable into the
connector on the rear panel of the Intellio C320Turbo Control Board. Refer to the
chapter 5 for the cable pinouts details.
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
25-signal-pin
Cable
00
UART Module UART Module CPU Module
C: Plug the other DB25 female end into the CPU Module's DB25 connector.
With power adapter (for range extension/external power
condition)
In case of range extension or external power requirement, users need a power adapter.
A: Set the CPU Module power switch to the OFF position. This is absolutely
necessary when installing or removing the cable, the CPU Module or the UART
Module(s). Power should not be switched on until you installed all
components.
B: Plug the DB25 male end of the shipped 2-meter 10-signal-pin cable (the one
comes with long range extension kit or the one fabricated according to the
pinouts in Chapter 5) into the connector on the rear panel of the Intellio