User`s manual

2-2 Intellio C320Turbo User's Manual
JP1 (ON: install jumper) (*: default)
1 2 3 4 5 6 7 8 9 IRQ
ON OFF OFF OFF OFF OFF OFF OFF OFF 2
OFF ON OFF OFF OFF OFF OFF OFF OFF 3
OFF OFF ON OFF OFF OFF OFF OFF OFF 4
OFF OFF OFF ON OFF OFF OFF OFF OFF 5
OFF OFF OFF OFF ON OFF OFF OFF OFF 7
OFF OFF OFF OFF OFF ON OFF OFF OFF 10*
OFF OFF OFF OFF OFF OFF ON OFF OFF 11
OFF OFF OFF OFF OFF OFF OFF ON OFF 12
OFF OFF OFF OFF OFF OFF OFF OFF ON 15
Step 4: Choose a base address (occupying 16KB) which is not used by expansion
memory or other add-in boards, such as SCSI adapter.
If you are installing more than one Intellio C320Turbo board, each board must have an
unique memory address.
Set the switch SW1 to the desired address as shown in the table below. SW1 can be
accessed without removing your PC's cover after the board has been installed. Note
that all MOXA drivers support the 6 base addresses below 1 MB, which are listed
below. For UNIX users, base addresses above 1 MB and below 16 MB are available,
please refer to Appendix.
SW1 Dip switch settings (*: default)
1 2 3 4 5 6 Base Address
ON OFF ON ON ON ON C8000
OFF OFF ON ON ON ON CC000
ON ON OFF ON ON ON D0000
OFF ON OFF ON ON ON D4000
ON OFF OFF ON ON ON D8000
OFF OFF OFF ON ON ON DC000*
Note!!! Make a note of the selected IRQ number and base memory address
for software driver configuration use later.
Step 5: Remove the slot cover bracket if present.
Step 6: Plug the Intellio C320Turbo Control Board firmly into any unused 16-bit