User`s manual

MOXA EtherDevice Server User’s Manual
A
-2
Power requirement CP-132 420 mA max. (+5V)
CP-132I 700 mA max. (+5V)
CP-132IS 710 mA max. (+5V)
Dimensions CP-132 120 × 80 mm (W × D)
CP-132I 120 × 110 mm (W × D)
CP-132S 120 × 80 mm (W × D)
CP-132IS 120 × 110 mm (W × D)
PCI
The 32-bit Industio CP-132U Series board complies with PCI Specifications 2.1. The IRQ
and I/O address hardware configuration is automatically assigned by the PCI BIOS. This
means that you must first plug in the board before installing the driver software.
As opposed to ISA slots, different PCI slots in the same PC may have different bus
numbers and device numbers with respect to the PCI specifications. The same PCI board
will have different system configurations if switched to a different PCI slot; this is called
slot-sensitive or slot-dependent. This may also apply to PCI slots in a PC with a different
motherboard, which may use different device number sets. For example, some use 17, 18,
19, and 20 for identifying the respective PCI slots, but some use 11, 12, 13 and 14.
Due to slot-dependency, it is necessary to re-configure the driver software once the
board is plugged into different PCI slots.
Up to 4
Industio CP-132U Series boards are allowed in one system. When installing more
than one board, please remember the order the boards are installed to distinguish the
installed boards from each other.
.