User`s manual

Industio CP-132 Series User’s Manual
3-16
Board and Port Ready Stage
The Board and Port Ready Stages for Windows 95 and Windows 98 are slightly different.
This last stage completes the driver installation.
Windows 95 Windows 98
After configuring the ports, you can immediately
use the COM ports of the
Industio CP-132U Series
board without restarting Windows 95.
After configuring the ports, click the [Finish]
button. The COM ports of the Industio CP-132U
Series board can be used without restarting
Windows 98
Note! If an error message similar to “CP-132U Series(BusNo=x, DevNo=x,
Port1=COMx) interrupt number is invalid!” pops up, refer to the “Troubleshooting” chapter
for solutions.
If you want to add more boards after the driver has been installed, simply plug in the
Industio CP-132U Series board and Windows 95/98 will automatically detect the new
board, and then skip to the Port Configuration stage to take care of port settings.
At this point, the driver installation of the Industio CP-132U Series is complete (including
board and port configuration). However, if you need to make changes to the board or port
configuration, refer to the next section, “Configuring the Board and Ports,” for more
configuration details.
Once the board and the driver are installed and the driver restarts successfully, you can start
to develop applications with the PComm
PCommPComm
PComm library (see “Serial Programming Tools”) or the
Microsoft Win32 API. You can also execute any ready-made applications, such as PComm
PCommPComm
PComm
utility Terminal emulator (see “Serial Programming Tools”) or HyperTerminal to
transmit/receive data, as well as Remote Access Service to provide dial-up networking
capabilities.