User`s manual

Software Installation
Industio CP-132 Series User’s Manual
3-5
8. The [Port #] window will open to allow you to change settings, as described below, for
that particular port.
Port Number
You must set up all of the board’s ports with the desired “COM number,” which
should not conflict with other COM numbers in use. In this “Individual Port Setting”
dialog box, there are two ways to map physical ports to COM numbers, depending on
whether you check the “Auto Enumerating COM Number” box.
If “Auto Enumerating COM Number” is checked, and the COM number of the first
port is specified, then subsequent ports are mapped to the next available COM number.
For instance, if the first port is mapped to COM3, then the second port is mapped to
COM4.
If “Auto Enumerating COM Number” is not checked, specify the COM number for
each port separately. For example, the second port could be mapped to COM10, and
the first port mapped to COM3.
Rx FIFO Trigger
You may choose from Rx FIFO trigger levels ranging from 1 to 56; with default value
set at 56 bytes.
Tx FIFO Size
You may choose a Tx FIFO size from between 1 and 64 bytes; with default value set at
64 bytes.