Specifications

Specification
Hardware
I/O controller
Connector type
16C550C or compatible x 2, each with
16 bytes Tx/Rx FIFO
Male DB9
Configuration
Performance
OS supported
Power and Environment
44
Port
Interface
232 422 485
2 4 8 16 32
Interface
Signals
Bus interface
Serial interface
No. of port
PCI ver. 2.1(32bit)
RS-422/485
2
RS-422: TxD+/-, RxD+/-, RTS+/-,
CTS+/-, GND
RS-485: Data+/-, GND
50 ~ 921.6K bps
8 (4 boards)
Parity
Data bits
Stop bits
IRQ
I/O address
None, even, odd, space, mark
5, 6, 7, 8
1, 1.5, 2
CP-132
CP132I
CP-132S
CP132IS
Windows 2000, Windows NT,
Windows 95/98, DOS
Power requirement
RS-485 data control
Built-in
termination resistor
Auto (Automatic Data Direction
Control) or by RTS
RS-422: 120 Ohm
RS-485: 120 Ohm, jumper enable/
disable
Assigned by BIOS
Assigned by BIOS
430mA max. (+5V)
700mA max. (+5V)
Speed
Max. no. of port
CP-132/ CP-132S :
CP-132I/ CP-132IS:
Ordering Information
CP-132
CP-132S
CP-132I
CP-132IS
All items include
2 ports RS-422/485 board (PCI), DB9
connectors
2 ports RS-422/485 board (PCI) with
surge protection (25KV ESD), DB9
connectors
2 ports RS-422/485 board with
optical isolation (2KV), DB9
connectors
2 ports RS-422/485 board with
optical isolation (2KV) and surge
protection (25KV ESD), DB9
connectors
Windows NT, 95/98 and DOS drivers
and manual
MOXA PComm Lite serial comm
developing tool
0 ~ 55J
Operating temp.
Dimension
120mm x 80mm
120mm x 80mm
Surge Protection
Isolation Protection
120mm x 110mm
120mm x 110mm
CP-132S: 8KV ESD
CP-132IS: 8KV ESD
CP-132I: 2KV
CP-132IS: 2KV
CP-132:
CP-132I:
CP-132IS:
CP-132S: