User`s manual

Software Installation
Industio CP-114 User's Manual 3-7
3. Click on the [Properties] button to open the “Moxa Smartio/Industio Configuration
Panel” dialog box. Please see steps 6-10 in the previous section, “Installing Driver”, for more
details.
Adding/Removing Board
Following is the procedure to add/remove Industio CP-114 boards after a first time installation. Note
that the presence of the board(s) is(are) required for adding/removing boards.
1. Power off the system.
2. Plug/unplug the boards in the system.
3. Power on the system.
4. Run the software configuration to setup the boards, as shown in the previous section.
Updating Driver
To update the driver for the Industio CP-114 board, simply remove the driver, as described in the next
section, and then reinstall it as detailed in the “Installing Driver” section.
Removing Driver
To remove the driver for the Industio CP-114 board,
1. Open the [Control Panel], click on the [Network] icon, and select the [Adapters] tab.