User`s manual

Hardware Installation
Industio CP-114 User's Manual 2-3
Connecting the Fan-out Cable
Step 5: Connect the fan-out cable (DB37 to DB9 x 4).
Step 6: Power on the PC and the BIOS will automatically set the IRQ and I/O address.
Note ! Each board must occupy one unique IRQ and four 8-byte
I/O addresses, which are assigned automatically by the
BIOS. However, you can select a free IRQ number manually via the PC’s
BIOS setup for the PCI slot, but normally this method is not available for the
I/O address. The possible IRQ numbers are 2, 3, 4, 5, 7, 10, 11, 12, and 15.
The possible I/O addresses are from 0x0000 to 0xFFFF.
Step 7: Proceed with the software installation detailed in the next chapter, “Software
Installation”.
Fan-out Cable Industio CP-114
JP1
JP2
JP4
JP3
ON
1 2 3 4
ON
1 2 3 4
RS-232 RS-422
RS-485
JP5
RS-232
RS-422
RS-485
JP6
By RTS RS-422
SW2 SW1
AUTO RS-485