User`s manual

Universal PCI Board User’s Manual Driver Installation: Windows NT
6-6
7. The board will now appear in the configuration panel (CP-168U Series in this example). Click
OK to return to the Network applet. After that, click OK again to exit the Network applet
8. Restart the PC. After you have logged back into Windows NT, you may check the event log
issued by the MOXA driver to see if the board’s ports have been initialized successfully. In the
Administrative group, open Event Viewer and select Log and System. For each newly
installed or configured Moxa UPCI board, check for a message stating that the board has been
enabled (e.g., “MOXA CP-168U V2 board, with first serial port COM3, has been enabled”).
ATTENTION
The driver configuration will NOT take effect until you restart the PC.
Double check that all CP-168U V2 board components are connected and fastened tightly to ensure
that the system and the driver can start up successfully.