User`s manual

Universal PCI Board User’s Manual Driver Installation: Windows NT
6-3
Installing the Driver
You will need to plug the board in an available PCI or PCI-X slot first, before installing the driver.
Note that these instructions use the CP-168U V2 as an example. The procedure for installing all
models is the same.
1. Log into Windows NT as Administrator.
2. Locate the appropriate folder for your board’s drivers on the Document & Software CD. The
NT drivers will be located under the product folder in the \Software\WinNT directory (e.g.,
under \CP-118U Series\Software). Copy this folder to the PC’s hard disk and remember its
location.
3. In the Control Panel, open Network applet. On the Adapters tab, click Add. When prompted
to select a product, click Have Disk…
You will be prompted to enter the path to the driver. Enter the location of the drivers that you
copied from the Document & Software CD (C:\Windows.nt in this example) and then click
OK.