User`s manual

Universal PCI Board User’s Manual Driver Installation: Windows Vista
3-3
Installing the Driver
The following instructions show how to install the driver for the first time under Windows Vista.
You will need to plug the board in an available PCI or PCI-X slot first, before installing the driver.
ATTENTION
The following steps will not be necessary if a MOXA UPCI board was already installed on your
computer. Windows will automatically detect and install any additional board(s) at bootup. In this
case, you may proceed directly to configuring the ports.
Note that these instructions use the CP-118U as an example. The procedure for installing all models
is the same.
1. After the board is physically installed and the PC boots up, Windows will automatically detect
the new board. The Found New Hardware Wizard window will open automatically. Select
Locate and install driver software (recommended).