User`s manual

Universal PCI Board User’s Manual Hardware Installation
2-16
Plugging the Board into an Expansion Slot
ATTENTION
Safety First!
To avoid damaging your system and board, make sure your PC’s power is turned off before
installing your Universal PCI Board.
Step 1:
Power off the PC.
Step 2:
Shut off the power to any peripheral devices and remove the PC’s cover.
Step 3:
Configure the UPCI board’s DIP switches and jumpers as necessary. This only applies to
certain models. For additional information, please refer to your model in this chapter.
Step 4:
Insert the board firmly into a free PCI or PCI-X slot on the PC.
Step 6:
Use a screw to secure the board in place.
Step 7:
Replace the PC’s cover.
Step 8:
Power on the PC. The BIOS will automatically set the IRQ and I/O address. Each MOXA
UPCI board uses one unique IRQ and I/O address, both of which are assigned
automatically by the PCI BIOS.
Step 9:
Install the software. For details, please refer to the appropriate chapter for your operating
system.