Installation guide

— 11 —
DIP Switch Settings
EDS-308 Series DIP Switches EDS-305 Series DIP Switches
12345678
ON DIP
12345
ON DIP
ON: Enables the corresponding PORT Alarm. If the port’s link fails, the rela
y
will form an open circuit and the fault LED will light up.
Off: Disables the corresponding PORT Alarm. The relay will form a close
d
circuit and the Fault LED will never light up.
LED Indicators
The front panel of MOXA EtherDevice Switch contains several LED indicators.
The function of each LED is described in the table below.
LED Color State Description
On
Power is being supplied to power input
PWR1
PWR1
AMBER
Off
Power is not being supplied to power
input PWR1
On
Power is being supplied to power input
PWR2
PWR2
AMBER
Off
Power is not being supplied to power
input PWR2
On
When the corresponding PORT alarm is
enabled, and the port’s link is inactive.
FAULT
RED
Off
When the corresponding PORT alarm is
enabled and the port’s link is active, or
when the corresponding PORT alarm is
disabled.
On TP port’s 10 Mbps link is active
Blinking Data is being transmitted at 10 Mbps
10M
GREEN
Off TP Port’s 10 Mbps link is inactive
On TP port’s 100 Mbps link is active
Blinking Data is being transmitted at 100 Mbps
100M
(TP)
GREEN
Off 100BaseTX Port’s link is inactive
On FX port’s 100 Mbps is active
Blinking Data is being transmitted at 100 Mbps
100M
(FX)
GREEN
Off 100BaseFX port is inactive